Axia Discussion Board

I am currently using the channel on/off logic of an IQ console to do route changes via Pathfinder. Example: LW channel 12101 logic is tracked to change the IQ-1 PGM 3 LW output to a different destination if the ON button of the IQ-1 console is pushed and change the path back to the default when the ...

Got it. Was able to set virtual GPIO and sense a USER Button push with pathfinder pc and change a route. Is there a way for pathfinder pc to create a latching situation with a IQ user button like you can with a software button? example: USER A lit when pressed, changes to route A and remains lit as ...

How does one get a user button to lite? I mapped the gpio and can make a route change when the User A button is pushed on the IQ by setting an event up in pathfinder server, but would like to also have an action if met that will turn the light the button on.

I see the new firmware for the IQ QOR32 has been released. In the release notes, it states it requires surface firmware 5.15 or better. The latest surface firmware available is 5.11. Is there soon to be a surface firmware release?javascript:emoticon(':?:')

When will there be new firmware available for the IQ console that will support the user button option? I see the manual has been updated, but no new software for the engine.

I see Pathfinder is capable of see a channel change on an Element console. Is there any plans for pathfinder to see a channel change from an IQ console? It would be nice for routing if Pathfinder could determine if the channel is on PGM 1, 2, or 3 as a qualifier. Then an appropriate route could be m...

Got it. I had it wired improperly. If functions fine. I am looking for a gpi to make route changes for EAS.

I am looking to wire an EAS closure to my IQ GPIO port 8. On an active low to pin 11, I would like it to be seen on the livewire network. I have an ASI 6585 card that can route gpio with a livewire source. If I make the IQ Livewire output 4 the EAS analog channel 4, should it not track the gpi throu...

Is pathfinder able to sense a gpio from the IQ console? More specifically can it detect a console fader ON button?

Dave

Hi Milos,

How did you create the state button in the youtube example? I assume you have to use stacking events to do so.

Dave

In version 4.55 RC 11 a latching function was added to the qualifier in stacked events. I assumed this would also work when linking with the software panel buttons, but an infinite loop was created and I had to resort to the older method of writing to a memory slot to avoid the loop. Works fine now....

I setup a single latching button software panel. All functions work fine except the stack event actions that change the button caption on the button will not push the change to the Software button panel. The caption is to change from Test-PGM to Test-Auto depending if the qualifier is met or not met...

I do not have a DHCP server on the network. It is a separate Axia network only. I will call tech support.

Still no luck. It will not take the netmask. After running the bootps file you suggested I download, it says it applies 192.168.0.142 with a netmask of 255.0.0.0. If I then run the Iprobe bootps program again it will still show the old netmask, so I assume it is not taking. My setup has a netmask of...

the netmask it has is 3.32.8.165 and won't take any change. The NET led does not stay lit. The connection is direct to cisco switch on a known working port. Iprobe does not find it when it scans. Is it suppose to recognize a button device? I'm starting to think there is a faulty nic in the OLED pane...