Axia Discussion Board

A customer asked about the possibility to use his 5 button film caps acc module located on his Element as a router controller for three recording devices. He wanted to be able to select which recording device and then select the 1 of 4 sources to record.

(http://www.youtube.com/watch?v=72TX1xwX4IY) bad link
new link
http://www.youtube.com/watch?v=6QT5cjahjms

for a preview

Hi Milos,

How did you create the state button in the youtube example? I assume you have to use stacking events to do so.

Dave

That was a long time ago, but yes, it was a stack event that was made which allowed for all the control and status feedback.

I imagine that I built the logic of the top button to control a memory value. This memory value than defines the states for the other buttons.

milos