Axia Discussion Board

I am looking to wire an EAS closure to my IQ GPIO port 8. On an active low to pin 11, I would like it to be seen on the livewire network. I have an ASI 6585 card that can route gpio with a livewire source. If I make the IQ Livewire output 4 the EAS analog channel 4, should it not track the gpi through to the network. The EAS is wired to IQ input 4 and the source profile is setup for analog 4.

Is it possible to wire an IQ gpi to be seen over the livewire network? If so, how?

A question to be answered is how do you plan to use this GPI?

The activity on the port can be seen on the network.

Just wire up the port, no need to configure as you mentioned.

The question again is how do you plan to use this closure? That is going to be the challenge.

Got it. I had it wired improperly. If functions fine. I am looking for a gpi to make route changes for EAS.