Hi all, is it possible, without Pathfinder, to control (i.e. switch on and off) the LEDs in an Element film-cap switch panel from a GPIO node elsewhere on the network?
Thanks
Andy
Controlling user button LEDs from GPIO port?
Moderator: AXIA_milos
-
- Posts: 40
- Joined: Mon Sep 01, 2008 2:08 am
- AXIA_milos
- Axia Team
- Posts: 281
- Joined: Fri May 25, 2007 2:54 am
- Location: San Luis Obispo, CA
Re: Controlling user button LEDs from GPIO port?
In Element User Module link, the filmcaps can be defined as a User module (used with Pathfinder) or GPIO module (tied to LW channel logic), or GPIO snake (again tied to LW channel but used with a port such the GPIs make the buttons light and button press make tthe GPO trigger)Andy Linton wrote:Hi all, is it possible, without Pathfinder, to control (i.e. switch on and off) the LEDs in an Element film-cap switch panel from a GPIO node elsewhere on the network?
-
- Posts: 40
- Joined: Mon Sep 01, 2008 2:08 am
- AXIA_milos
- Axia Team
- Posts: 281
- Joined: Fri May 25, 2007 2:54 am
- Location: San Luis Obispo, CA