Hello,
Is it possible to configure remote control of TWOx12 via Ethernet from Element's Monitor+2-fader module?
I mean, I want to answer to incoming call by opening the corresponding fader channel (or by hitting preview button). This is working with Telos TWO ISDN, but is it possible with TWOx12?
Thank you,
Nick
remote control of TWOx12 from monitor+2-fader module SOLVED
Moderator: AXIA_milos
-
- Posts: 17
- Joined: Wed Jul 11, 2007 10:23 am
- Location: St.Petersburg, Russia
- Contact:
- AXIA_milos
- Axia Team
- Posts: 281
- Joined: Fri May 25, 2007 2:54 am
- Location: San Luis Obispo, CA
-
- Posts: 17
- Joined: Wed Jul 11, 2007 10:23 am
- Location: St.Petersburg, Russia
- Contact:
Milos, thank you for answering.
Although, it would be of interest to have this feature. Faders of 2001-10221 monitor+2-fader module have 2 buttons: Set and Hold, which make life easier when working with hybrids. 2x12 system has 2 audio ports, so it seems to be reasonable using it particular with that module in smaller setups, rather than with 4-fader phone module (2001-10179).
Nick
Although, it would be of interest to have this feature. Faders of 2001-10221 monitor+2-fader module have 2 buttons: Set and Hold, which make life easier when working with hybrids. 2x12 system has 2 audio ports, so it seems to be reasonable using it particular with that module in smaller setups, rather than with 4-fader phone module (2001-10179).
Nick
This is possible starting with Element v2.0
This feature is advertised as Euro-Mode for Telos Nx12, but will also work for 2x12.
To use this feature you need to make following configuration:
in source profile for phone source you should fill those fields:
Phone hybrid ip: <ip of a 2x12>
Phone line: <phone line you want to use>
Phone hybrid (for Nx12): <phone hybrid number>
Phone Module ID: should be set to <NO>
Hybrid Nr.(0 - None): should be set to 0
Then after you load this source you will be able to control the 2x12 without the call control module (just like in Telos TWO case).
This feature is advertised as Euro-Mode for Telos Nx12, but will also work for 2x12.
To use this feature you need to make following configuration:
in source profile for phone source you should fill those fields:
Phone hybrid ip: <ip of a 2x12>
Phone line: <phone line you want to use>
Phone hybrid (for Nx12): <phone hybrid number>
Phone Module ID: should be set to <NO>
Hybrid Nr.(0 - None): should be set to 0
Then after you load this source you will be able to control the 2x12 without the call control module (just like in Telos TWO case).