Page 1 of 1
Controlling user button LEDs from GPIO port?
Posted: Thu Feb 21, 2013 4:52 pm
by Andy Linton
Hi all, is it possible, without Pathfinder, to control (i.e. switch on and off) the LEDs in an Element film-cap switch panel from a GPIO node elsewhere on the network?
Thanks
Andy
Re: Controlling user button LEDs from GPIO port?
Posted: Wed Mar 20, 2013 2:24 am
by AXIA_milos
Andy Linton wrote:Hi all, is it possible, without Pathfinder, to control (i.e. switch on and off) the LEDs in an Element film-cap switch panel from a GPIO node elsewhere on the network?
In Element User Module link, the filmcaps can be defined as a User module (used with Pathfinder) or GPIO module (tied to LW channel logic), or GPIO snake (again tied to LW channel but used with a port such the GPIs make the buttons light and button press make tthe GPO trigger)
Posted: Thu Apr 25, 2013 6:21 pm
by Andy Linton
I see that Milos, but could you explain please how to map that to a port on a GPIO node?
Thanks
Andy
Posted: Fri Apr 26, 2013 5:02 am
by AXIA_milos
1) set filmcap to GPIO Snake, assign a unique number.
2) GPIO node, set to the same number.
Posted: Fri Apr 26, 2013 1:46 pm
by Andy Linton
Ok thanks.
A.